Abus TVCC71000 User Manual

Other manuals for TVCC71000: User Manual
Manual is about: dome camera

Summary of TVCC71000

  • Page 1

    19 vandal proof wd dnr day/night vario 650 tvl outdoor dome camera version 12/2010 original english user manual. Keep for future use. Tvcc71000 tvcc71500

  • Page 2

    20 Ŝ introduction dear customer, thank you for purchasing this product. This product meets the requirements of the applicable european and national guidelines. The corresponding declarations and documents can be obtained from the manufacturer (www.Abus-sc.Com). To maintain this condition and to ensu...

  • Page 3

    21 important safety instructions the warranty will expire for damage due to non-compliance with these operating instructions. We shall not be liable for any consequential loss! We do not accept liability for damage to property or personal injury caused by incorrect handling or non-compliance with th...

  • Page 4

    22 table of contents 1. Intended use ....................................................................................................................... 23 2. Explanation of symbol .................................................................................................. 23 3. Scope of d...

  • Page 5

    23 1. Intended use the vandal proof 650tvl outdoor dome camera is equipped with a high quality image sensor. It is used for video surveillance in connection with a recorder or monitor. You can find a detailed description of functions in section “4. Features and functions”. Any other use than that de...

  • Page 6

    24 5. Description of device 5.1 overview – item numbers item number tvcc71000 tvcc71500 resolution 650 tvl 650 tvl lens 2.8~10.5 mm 2.8~10.5 mm ir - day/night (removable ir cut filter) voltage 12 vdc 12 vdc 5.2 unpacking while you are unpacking the device please handle it with utmost care. If you no...

  • Page 7

    25 for this camera type the camera module can be removed, and it is fixed by two fixing screws. Base part of the camera and camera module are connected by a 15 pin d-sub joint. Unscrew the fixing screws, and carefully remove the camera module. Place the base part to the desired installation position...

  • Page 8

    26 6.3 connectors before you start with the installation please make sure that the supply voltage and the nominal voltage of the camera comply together. Power supply & video signal video output (for service purpose) 1 video output (primäry), bnc (female), fbas 1vs-s 2 power connector (round plug 5.5...

  • Page 9

    27 6.5 focus and zoom adjustment the cameras tvcc71000 and tvcc71500 are equipped with a vario focal lens. On the bottom side of the lens two adjustment handles for focus and zoom ratio are positioned. The handles additionally act as a fixing screw for the focus and zoom adjustment. The fixing handl...

  • Page 10

    28 6.7 camera parameter (osd menu) setup menu white bal atw backlight off pict adjust atr on privacy off nr camera id off camera reset exit € save all funktion beschreibung white bal settings for white balance function backlight settings for back light handling pict adjust general image settings atr...

  • Page 11

    29 white balance (white bal) function description atw auto tracking white balance the setting for the white balance function will be performed dynamically and continuously in the range of 1800~10500k. Push continuous setting for the white balance with limitation of color temperature range user1 / us...

  • Page 12

    30 atr function description atr settings for the wide dynamic function (adaptive tone reproduction) off: wide dynamic function deactive on: wide dynamic function active luminance (low/mid/high): level of the brightness balance. Dark areas will be displayed more bright (low->high), in addition the br...

  • Page 13

    31 nr function description nr settings for the noise reduction (2d dnr) off: noise reduction deactivated nr mode (y/c/ y/c): y: noise reduction for luminance signal c: noise reduction for chroma signal y/c: combination of noise reduction for luminance and chroma y level (0~15): level for the noise r...

  • Page 14

    32 7. Service and cleaning 7.1 function test check the technical safety of the product such as damage to the housing at regular intervals. When it can be assumed that the safe operation is no longer possible, the product must be put out of service and precautions taken o ensure that it is not used u...

  • Page 15

    33 9. Technical data item number tvcc71000 tvcc71500 tv standard pal resolution 650 tvl bildaufnehmer 1/3‘‘ sony exview had ii ccd dsp sony effio-e picture elements (total) 1020(h) x 596(v) picture elements (effective) 976(h) x 582(v) signal-to-noise ratio 50 db minimum illumination (day) 0.05 lux @...

  • Page 16

    34.