Acard AEC-6290 User Manual - page 21
AEC-6290/6295 Manual
21
4.1.2 Boot from AEC-6290/6295
NOTICE: During driver installation, if you encounter the problem of Win-
dows logo, please click “Continue Anyway”. Windows logo is a mechanism
designed to prevent OS from working abnormally because of installing
unidentified software. Yet, the driver of AEC-6290 or 6295 is proven not to
affect the entire work of OS.
Please follow the steps given below to install a new OS to the hard drive connected
to AEC-6290/6295. Thus you can boot from the adapter.
(1). Find the support CD containing the driver of AEC-6290/6295 from the package.
Copy the driver into a formatted floppy disk, and label it. Refer to Appendix A.
(2). Place the original CD of Win 2000 or XP into CD-ROM, and boot from hence.
(3). On seeing the first blue screen, you need to press
hard drive connected to SCSI or RAID card. After the installation program loads
needed files, please press and put the driver disk into floppy drive.
(5). The installation program will load the driver of AEC-6290/6295. And you can
select the hard drive or array into which you intend to install the OS. Then
follow the wizard to complete.
(6). During installation, if you encounter the problem of Windows logo, please click
“Continue Anyway”.
4.2 In Win NT
4.2.1 Install the Driver
Please follow the steps given below to install the driver of AEC-6290/6295.
(1). After installing the adapter, boot the original system again.
(2). Click “My Computer”, “Control Panel”, “SCSI Adapters”, and “Drivers”. Then
click “Add”. Put the driver disk or CD of AEC-6290/6295, and specify the driver’s
location.