Acard AEC-6293M User Manual - 2.2 Software Installation
7
AEC-6293M Manual
PCI Slot
4. Screw the AEC-6293M onto the chassis
5. Connect AEC-6293M with a SATA/ IDE hard drive via SATA/ eSATA/ IDE cable and connect
the power cord to the hard drive properly.
6. Clost the chassis and power on the system.
7. If you have external eSATA system, connect AEC-6293M with external SATA system via eSATA
cable.
Please follow the 7 steps to install AEC-6293M
1. Be sure that the system power has been off.
2. Open the chassis of Mac.
3. Insert AEC-6293M into an available PCI slot.
Notice:
The Serial ATA cable is used to transfer data in very high frequency. It is suggested no to
connect and disconnect offten, or the connector could be damaged.
2.2 Software Installation
No extra driver is required during the installation. The OS will detect and install the driver
automatically.
You may check information about the adapter from "System Profile".
2.1 Hardware Installation
Please follow the 7 steps to install AEC-6293M
1. Be sure that the system power has been off.
2. Open the chassis of Mac.
3. Insert AEC-6293M into an available PCI slot.