Acard AEC-6710S User Manual - Step 6:
Step 6:
Please terminate the last SCSI device on this cable.
Note:
For terminating your internal SCSI device, please
refer to your original SCSI devices supplier or
manufacture.
Step 7:
Identify your devices number, that is, you have to set
all your internal SCSI devices an unique number to
avoid hardware conflict.
2.1.3 Installing External Drives
Power Connection
For external SCSI devices, you need to connect the power core to turn on
your external device. Please refer the graph below to see how to connect
your power core to your external device.
Cable Connection
Let’ s discuss two different ways to make external cable connection by
number of devices, only one device connected and more than one devices
connected.
1. Connecting only one device
Step 1:
Please identify the number of pins on connectors,
either adapter or device. Then, prepare a external
cable whose connectors match your need,
e.g. 50-pin to 50-pin, 68-pin to 68-pin, or 68-pin to 50-pin.
Step 2:
Plug one end of the high-density external SCSI cable
into the host adapter’s D-Sub connector.
Step 3:
Plug the other end of this SCSI cable into one
connector on the SCSI device you are going to connect.
Step 4:
Enable the terminator on device.
Chapter 2 Installation
7