Accele RS505 Installation Instructions

INSTALLATION INSTRUCTIONS                                          Part # RS505

WIRELESS KEYPAD TYPE KEYLESS ENTRY

CODE LEARNING (FOR FOUR BUTTON TRANSMITTER)   

OPTIONAL ITEM

To replace lost or stolen transmitters. Please have all desired transmitters ready and follow the 

steps below.

Put the DIP SWITCH 1 to ON (UP) position. The parking light will flash TWICE to indicate the module 

1. 

is in code learning mode.

Press and release any button on the transmitter. The parking will flash FOUR times to confirm the 

2. 

NEW code has been learned.

Put the DIP SWITCH 1 to OFF (DOWN) position to exit the code-learning mode.

3. 

     (ONLY ONE FOUR BUTTON AND ONE KEYPAD CAN BE PROGRAMMED TO OPERATE THE SYSTEM)

CODE LEARNING (FOR KEYPAD TRANSMITTER

)

NOTE: THE KEY PAD THAT COMES WITH THE SYSTEM IS ALREADY CODED.

To replace a lost or stolen transmitter please have the NEW keypad ready and follow the steps 

below.

 (EACH KEYPAD HAS ITS OWN 4 DIGIT CODE NUMBER. MAKE SURE YOU HAVE THE 4 DIGIT 

CODE NUMBERS READY BEFORE INTO THE CODE LEARNING MODE).

Put the DIP SWITCH 1 to ON (UP) position. The parking will flash TWICE to indicate the module is in 

1. 

code learning mode.

Enter the 4-digit code then press 3/4 button on the keypad. The parking light will flash FOUR times to 

2. 

confirm the NEW code has been learned. If the parking light does not flash after inputting the 4-digit 

code and press the 3/4 button. These means the NEW code have not been learn. Please double 

check the codes and try again.

After the NEW code has been learned into the system. Put the DIP SWITCH 1 to OFF (DOWN) 

3. 

position to exit the code-learning mode.

TO CHANGE THE PIN CODE:

Press and hold the button 9/0 on the keypad for 3 seconds. The LED on button 9/0 will flash 

1. 

THREE times and the back ground light will flash TWICE very quick to confirm the module is now 

in code-learning mode.

Enter the OLD 4 digit user code, in the last digit press and hold for 2 second. If the OLD user 

2. 

code is correct, the LED light and background light on button 9/0 will flash ONCE. If the LED light 

and background light on button 9/0 flash TWICE to indicate the old user code is incorrect and will 

exit the code-changing mode.

Please repeat the steps above and try again.

3. 

Enter the NEW PIN code (3~7 digits), hold down the last digit for 2 seconds. If the NEW PIN code 

4. 

is accepted the LED light and background light on button 9/0 will flash ONCE to indicate the NEW 

PIN code is accepted.  If the NEW PIN code is NOT accepted. The LED light and background 

light will flash TWICE to indicate the code is NOT accepting it. and exit the code changing code.

Enter the NEW PIN code (3~7 digits) again; hold down the last digit for 2 seconds to confirm the 

5. 

NEW CODE. If the NEW CODE is accepted the LED light and background light on button 9/0 will 

flash ONCE and turn OFF to indicate the NEW PIN code is accepted.

If the NEW PIN code is NOT accepting it. Please repeat the steps above and try again.

6. 

After the NEW PIN code has been accepted into the system. Please write down the NEW PIN 

7. 

code and keep it in a safe place. If the NEW PIN code is lost there is NOWAY to read the new pin 

code that your have enter to the system.

ACCELE ELECTRONICS                                          PAGE 1