Accele RS505 Installation Instructions - page 2
INSTALLATION INSTRUCTIONS Part # RS505
OPERATION MODE
(WITH KEYPAD OPERATION)
Enter the 4 digit PIN code then press button 1/2 on the keypad momentarily. The module will
1
send a signal to UNLOCK all the doors. The parking light will TWICE to confirm the operation
Enter the 4 digit PIN code then press button 3/4 on the keypad momentarily. The module
2
will send a signal to LOCK all the doors. The parking light will flash ONCE to confirm the
operation.
(A)Enter the 4 digit PIN code then press button 5/6 on the keypad momentarily. The
3
module will send a negative signal to the YELLOW/BLACK wire on the harness to
control an external relay.
(B)Enter the 4 digit PIN code then press and hold button 5/6 on the keypad. The
module will send a continuous negative signal to the YELLOW/BLACK wire on the
harness to control an external relay.
(THE SIGNAL WILL BE CONTINUOUS AS LONG AS THE BUTTON 5/6 IS PRESSED AND HELD DOWN)
(C) Enter the 4 digit PIN code then press button 5/6 on the keypad momentarily. The
module will send a LATCHED negative signal to the YELLOW/BLACK wire on the
harness to control an external relay. This signal will stay LATCHED until you enter
the 4 digit PIN code then press button 5/6 again to turn this signal OFF.
(THE DIP SWITCH #3 MUST BE SET TO ON (UP) POSITION TO SELECT THIS OPERATION FUNCTION).
WARNING: IF THE OPERATION MODE IS SELECTED. MAKE SURE THIS CHANNEL IS TURNED
OFF BEFORE LEAVING THE VEHICLE. FAILURE TO TURN OFF THIS FEATURE WILL
RESULT IN A DEAD BATTERY UPON RETURN TO YOUR VEHICLE.
(A) Enter the 4 digit PIN code then press button 7/8 on the keypad momentarily. The
4
module will send a negative signal to the PURPLE wire on the harness to pop the
trunk open or to control an external relay.
(ONLY IF THIS OPTION IS SELECTED. SOME VEHICLES MAY REQUIRE EXTRA PARTS
AND LABOR. PLEASE SEE YOUR DEALER FOR DETAIL).
(B) Enter the 4 digit PIN code then press and hold button 7/8 on the keypad. The
module will send a continuous negative signal to the PURPLE wire on the harness
to control an external relay.
(THE SIGNAL WILL BE CONTINUOUS AS LONG AS THE BUTTON 7/8 IS PRESSED AND HELD DOWN)
(C) Enter the 4 digit PIN code then press button 7/8 on the keypad momentarily. The
module will send a LATCHED negative signal to the PURPLE wire on the harness to
control an external relay. This signal will stay LATCHED until you enter the 4 digit
PIN code then press button 7/8 again to turn this signal OFF.
(THE DIP SWITCH #4 MUST BE SET TO ON (UP) POSITION TO SELECT THIS OPERATION FUNCTION).
WARNING: IF THE OPERATION MODE IS SELECTED. MAKE SURE THIS CHANNEL IS TURNED
OFF BEFORE LEAVING THE VEHICLE. FAILURE TO TURN OFF THIS FEATURE
WILL RESULT A DEAD BATTERY UPON RETURN TO YOUR VEHICLE.
ACCELE ELECTRONICS PAGE 2