Accelerated 6200-FX Troubleshooting manual - page 10
Accelerated Concepts, Inc. © 2015
10 of 16
6200-FX Troubleshooting Guide v1.3
Restore Default Settings
Restoring a 6200-FX device to factory default settings will clear out the settings obtained from the
6200-FX’s remote configuration and load the factory default settings. To restore a 6200-FX device
back to default settings, perform the following steps:
1. Power off the 6200-FX for at least two seconds.
2. Remove all USB devices from the 6200-FX.
3. Unscrew the modem cover from bottom of unit. Remove the cover to expose modem and
default reset switch.
4. Power on the 6200-FX and wait 30 seconds for the device to complete startup.
a. Note: at this point the only light that should be illuminated is a red USB LED.
5. Press the “Default Reset” button located on the circuit board of the 6200-FX.
6. Once the Default configuration button is pressed, ensure that the USB and Wireless LEDs of the
6200-FX are alternately flashing red and green. This indicates that the 6200-FX is applying the
default configuration.
7. Wait for the 6200-FX to reboot and apply the changes. Once the USB LED illuminates red and all
other lights are off, it is safe to power off the 6200-FX
8. Insert the modem cover and secure with screw.
Default Reset Switch