Access LORADO Installation Instructions And Owner's Manual - 2: Apply Element Seal
4
NOTE: For best adhesion, air and surface temperature should be above 60
0
F.
A. Clean underside of rail with
alcohol pad included. Hold seal up
to end of rail, make sure end of seal
contacts edge of box.
B. Mark leg of seal and cut notch in
seal.
Rail
Edge of
box
Mark for
cutting
Rear seal
Rail
A.
B.
2: APPLY ELEMENT SEAL
TM
GASKET
NOTE: For additional protection–locate and seal miscellaneous factory
holes, crevices, stake pockets, etc. that may be on box (sealant not included).
NOTE: For best adhesion, air and surface temperature should be above 60
0
F.
Align seal
against front
of rail and
inside edge of
box starting
here
B. Peel paper back, align and
adhere ELEMENT SEAL™ at one
corner across box to opposite corner
and cut to length.
A. At front of box header, clean top
surface with alcohol pad (if needed
wash first).
Save alcohol pad for
use in step #3.
Clean top of box
Side rail (shape may
vary from photo)
Rear seal