Access Point CT-5072T Installation Manual - page 4
Manual is about: Comtrend 1 Port Router
of
10
Comtrend Router Installation
3
Configure the DSL Interface
Using the information from your DSL confirmation e-mail, enter the correct VPI and VCI information for
your installation. Your VPI and VCI information may be different than what is pictured in this document.
You must use the information from your e-mail. Under the Select Connection Option, choose MSC Mode.
Do not change any other options on this page. Do not enable the QoS box. Then click Apply/Save.
Select PPPoE as the connection type
On the next page, you will need to setup your WAN service. Select the WAN Service option from the left
hand tab. Then select Add.