Accessory Power SLR Wireless RF Remote Instruction Manual - Remote Functions
Remote Functions
Inserting the CR2 battery
Insert the included (c) CR2 battery into the (10) CR2 battery compartment on the
(b) receiver.
Connecting the Receiver to your Camera
First, mount the (b) receiver onto the top of your camera with the (8) Hot-shoe
mount.
Next, insert the (7) Connection pin into the remote port on your camera. Please
refer to your camera’s user’s manual if you are having trouble.
Press the (4) receiver power button and you will see the (6) receiver LED glow red.
Turn your Camera’s power ‘ON’.
Single and Continuous Shooting
Please make sure the (2)mode switch on the (a)wireless RF remote is switched to
B. Press the (1) remote shutter release down half way to auto-focus. Once
focused, you can press the button down completely to take a single shot, or if you
have your camera set to continuous shooting, it will begin the series of shots.
Bulb Mode
Please make sure that your camera is set to Bulb Mode (Long Exposure). Please
make sure the (2) mode switch on the (a) wireless RF remote is switched to B.
Press down the (1) remote shutter release and hold it until the (3) remote LED turns
off . The red (6) receiver LED will turn on permanently to indicate that Bulb Mode is
active. To turn Bulb Mode off , just hold down the (1) remote shutter release again.