ACCO Brands Swingline GBC Fusion 3000L Start Here Manual - Getting Ready To Laminate

getting ready to laminate

NOTE:  Your new laminator may emit 

a slight odour during the initial 

operation. Its is normal and will 

diminish after a few hours of 

operation.

Easy Set Up

1

   Remove the plastic exit tray from the box and place into the two holes on the back of the 

laminator and extend to use. Ensure that there is sufficient space behind the laminator for the 

item to be removed.

2

   Take the electrical plug and place in an appropriate power source, which is near the table you 

intend to use.

3

   The laminator will respond with a single beep and a sequence of brief flashes across the control 

panel.

Touch Control

4

   To use the laminator gently tap the ‘power on’ button. 

NOTE:  Following “power on” it will 

automatically set to the 75mic. 

5

   An  orange  ‘ ’ will flash indicating that the laminator is warming up to the setting which is 

indicated by a white light on the control panel.

6

   If setting indicated by white light on the control panel is not approporaite for your pouch 

thickness, select the appropriate pouch setting by tapping the micron setting which is indicated 

on pouch packaging. Your new selection will be indicated by a white light on control panel.

English

6     

register this product online at www.acco.com