Accu ACCU-Turn 7700 Operation And Maintenance Manual - Assembly Of Brake Lathe
ASSEMBLY OF BRAKE LATHE
SETTING UP BRAKE LATHE FOR OPERATION
1. Three bolts hold brake lathe to pallet. Bolts can be removed by using 9/16" wrench
and gaining access to them from the underside o f pallet.
2. Brake lathe is shipped with arbor installed and torqued to 55 foot pounds of torque on
draw bar. Drum cutter is also installed.
3. Locate the three mounting holes on lathe bench that match the threaded holes on
underside of lathe. Install eye bolt in threaded hole provided on lathe (1/2" - 13 thread).
Be sure to screw the eye bolt into the lathe housing until fully seated.
4. Lift lathe from pallet and secure lathe to bench. Bolts are provided. At this time check
draw bar nut to ensure 55 foot pounds of torque.
5. Install holders for accessories on bench peg board as shown in catalog.
LUBRICATION
Felt wiper (Part #441228) on drum slide should be lubricated weekly with a 10W oil.
All machined unpainted surfaces should be sprayed with WD40 or equivalent as needed to
prevent rust.
An alemite grease fitting is provided to lubricate pivot arm assembly. Lubricate this pivot
arm every six months with molybdenum base grease. Using a hand operated grease gun,
inject "one pump" of grease.
Engage/Disengage Cam mechanism should be lubricated as needed with WD40 or
equivalent.
ELECTRICAL REQUIREMENTS
115 volts; 60 cycle, 10 amps.
Never operate this machine unless the power supply is correct and the machine is properly
grounded.
6