Acecad acedialer SD1 User Manual - 2. Getting Started
2
2. Getting Started
Installing the Battery into the Controller
1. Use a coin to counterclockwise remove the battery compartment cover.
2. Remove the battery (CR2032). And then remove the insulation slice.
3. Replace the battery (CR2032) with the positive side
(+)
facing up.
4. Replace the battery compartment cover and use a coin clockwise to tighten it.
Pairing the
Bluetooth
Controller
Before you can use the Controller with your phone, it has to be paired once with your
phone. To pair the Controller with your phone:
1. Press and hold the button
and button
at the same time (about 5 seconds) until
the indicator on the Controller slowly flashes.
2. Prepare your phone according to your phone user guide on how to add a Bluetooth
device.
3. From a list of discovered in-range Bluetooth devices, tap (or click by trackpad)
“
ACECAD SD1 Controller
” to initiate pairing. If asked for the PIN code, enter
0000
.
4. When successfully paired, the indicator light on the Controller turns off. You will find
that the
ACECAD SD1 Controller
will be shown in the paired device list in the
Bluetooth settings on your phone.
Note: The indicator light turns off if you do not pair the Controller with your phone
within one (1) minute.
Note: Before using the Controller with your phone, Bluetooth must be turned on in your