Aircalo VENTIS VT 3 Installation And Maintenance Manual - 3– Range Presentation
4
3– RANGE PRESENTATION
3-1 Presentation
The heater VT range is designed for heating and cooling :
3
2
1
2
1
3
4
5
Water heater
Designed to heat large volume buildings, this
heater is effective and polyvalent. It can be used
for direct blowing and fresh air supply. It can be
install vertically or horizontally.
Description
1– Exchanger is made of copper pipes with alu-
minium fins for good thermal efficiency.
Hot coil (low pressure) with 1, 2 or 3 rows de-
pending on the model. Tested at 105°C/ 8 bars.
2-Fan-motor assembly : motor with an external
rotor and profiled blades are welded on the rotor.
This technology ensure an excellent efficiency
and a low noise level.
3– Profiled louver series
Water heater with cooling option
Designed to heat and cold large volume buildings,
this heater is effective and polyvalent. It can be
used for direct blowing and fresh air supply. It can
be install only on the wall (horizontal blowing).
Description
1
-Exchanger is made of copper pipes with alumin-
ium fins for good thermal efficiency (as on the left)
2-Fan motor assembly (as on the left).
3-Profiled louver series
4-Moisture collector, avoid the condensation wa-
ter spray into the room which is refreshed.
5– Condensate drain pan. When the unit is cool-
ing, the ambient humidity condensates on the coil.
So it is necessary to recover it by connecting a
drain pan.