Aircalo VENTIS VT 3 Installation And Maintenance Manual - Installation
9
6
-
INSTALLATION
6
-
1 Mounting without bracket
Be careful, if the mounting is without bracket, it is necessary to respect the following instructions. Any
other mounting can damage the unit.
Suspended mounting and/or slinging
Install 2 fixing parts (no provided) one after another.
- Unscrew one of 2 screws M8 of the upper face of the heater.
- Put the first fixing part.
- Tighten the screw before to put the second fixing part.
(Fixing parts and hangers not provided)
Ceiled mounting (Vertical blowing) :
Install 4 fixing parts (no provided) in the threaded holes at the
rear of the heater.
6-2 Mounting with bracket
Caution: these brackets are not suitable for use with mixing box with dampers.
Montage
:
Before mounting the device, it is necessary to make sure of the support’s strength.
- Fix the brackets on the wall. Use the fasteners matched to the
wall material. Make a resistance testing.
- Fold the block tab of the brackets, see details on the right.
- Unscrew the 2 screws M8 on the upper face or on the lower face
according to the mounting (suspended or put down)
- Fix the heater with the previous M8 screws, block it.
- Block the rear of the unit with the tabs of the bracket by using the
pre-mounted screws on the rear of the unit.
Foresee a minimum space of 500 mm between the rear of the unit and the wall, to allows a correct air
supply and an enough temperature drop of the motor. (Brackets ensure a required space).
Fixing parts
(not provided)
Suspended with
brackets
Fixed on
brackets
Brackets dimensions
Type
length
height
Code
VT 3
660 mm
350 mm
EQVE1
VT 4
660 mm
350 mm
EQVE1
VT 5
780 mm
405 mm
EQVE2
VT 6
780 mm
405 mm
AQVE2
VT 7
See brackets manual
Blocking screw at the rear of
the console