Aircel DHT-100 Installation And Operation Manual - Caution!
High Inlet Temperature Refrigerated Air Dryer
9
Purpose and Intended Use
High inlet temperature refrigerated air dryers are
designed for the purpose of removing moisture
from the compressed air by using mechanical
refrigeration and providing dew points as low as
(48° F- 50° F). These dryers are used to protect
industrial compressed air systems, machinery, and
tools. They are designed to deliver the required
dew point at specified inlet air temperature, inlet
air pressure, inlet flow and ambient temperature
conditions. To ensure maximum performance and
safe operation of this dryer, everyone associated
with its installation, operation, and maintenance
must read and carefully follow the instructions of
this manual.
CAUTION!
• Misuse or modification of this
equipment may result in personal
injury.
• Do not misuse or modify.
Inspection on Arrival
All high inlet temperature series dryers are tested
and operated before shipment. However, shipping
vibration may cause damage such as loosening of
certain parts. To ensure smooth installation, it is
recommended that immediately upon receipt of the
unit, the system is checked for the following:
1. Inspect unit on delivery.
2. Report any damage to the delivery carrier.
3. Request a written inspection report from the
Claims Inspector to substantiate the claim.
4. File claims with the delivery carrier.
5. Compare unit received with description of
product ordered. Check the data label and
make sure that it is the correct Model that you
had ordered. Note the equipment Capacity and
Power Supply requirements and ensure that they
are in accordance with your specifications. The
rated conditions of the dryer are indicated on
the serial plate label. If there is any discrepancy,
contact your representative listed on the manual
back cover.
6. Vibration during shipping can loosen the
connections. So inspect all pipe and tubing and
make sure they are all tightened and secured.
7. Observe pressure of refrigerant analyzer gauge
(suction) to determine if refrigerant has leaked
out during transit. If the gauge reading does not
match that mentioned on the serial plate label,
immediately contact Technical Support listed on
the manual back cover.
8. Report incomplete shipments to the delivery
carrier and your service representative.