Aircommand sandpiper Owner's Manual - page 14
Sandpiper Installation Guide
28
th
May 2013 – Revision 7
Page
14
of
22
With “
”blinking, Press “
” or “
” to change set time
Press “
” for 3 seconds to change between On and Off timer setting
Press “
” for 3 seconds to cancel On/Off timer set for current day
Press “
” for 6 seconds to cancel all On/Off timer that previously set
System will save all settings and returns to main menu if there is no input for 10 seconds.
Note: “
” will be
displayed when the weekly timer has been set.
BUTTON LOCK
This provides a means of locking the mode and fan settings to prevent any unintended input
Press “
” and “
” for 3 seconds to activate button lock, to unlock repeat the procedure
“
” will display when button locked. Note
: On/Off “
” will not be affected by the button lock
TEMPERATURE DISPLAY SETTING
Press “
” and “
” for 5 seconds to change temperature measurement unit to either
℃
or
℉
REMOTE CONTROL INSTRUCTIONS
The functions on the remote control are the same as on the LCD touchscreen
except that the timer function can
only be set from the LCD touchscreen
(see Figure 11 for diagram)
The functions operate the same way if set by the remote or the LCD touchscreen
The clock icon is used to set the time on the remote. Press once and then adjust the time using the up/down
arrows. Press the up/down arrow once to move ahead/behind by 1 minute, hold up/down arrow to move
ahead/behind by 10 minutes. Once your desired time is displayed press “SET” to save this time on the remote.
The light bulb icon will switch the backlight either on/off. To switch the backlight on/off hold the light bulb icon
for 3 seconds.