Aircon Off SMART REMOTE User manual - Set Up Function Lock

Use of "Instant Cooling" "Instant Heating" Function

Pressing the "I COOL" button will turn on the air conditioner directly into cooling mode.  

Pressing the "I HEAT" button will turn on the air conditioner directly into heating mode.  

In both modes, the A/C will automatically select heating and cooling at a comfortable, 

economic temperature and the fan and swing functions will also be automatic. It is still 

possible to adjust the temperature by using the "Temp.+"  "Temp.-" keys as required. 

Clock Set Up

1. Press the "Clock" key once, the clock signal will flash. 

2. Press the "Time + or Time -" keys, to set the current time. 

3. Press the "Clock" key again, the time signal will stop flashing, the time is now set. 

(If you do not press the "Clock" key again, the function will auto-lock after 15 seconds) 

Conversions between Celsius and Fahrenheit 

Press the "C/F" key, the display will change between Fahrenheit and Celsius. 

Please Note: 

1. lf it is not intended to use the Smart Remote for an extended period, remove the 

batteries to avoid battery leakage which will damage the unit. 

2. The LCD normally displays the time. By pressing the "ENTER, OK" key, the current 

Model Code is showed on the LCD. After 5 seconds the display will return to the clock. 

Set Up Function Lock

The Settings Lock prevents unauthorised changes. (Tampering). Once the settings are 

correct the Set Up Function can be locked by pressing the “ENTER/OK” key once. 

Alternatively if no buttons are touched for 3 minutes, the Set Up Function will 

automatically lock. 

Troubleshooting

Dim Screen 

If the LCD looks dim, it is time to change the batteries. (Never mix new and old batteries 

together) When the batteries are replaced, the unit will remember settings so it is not 

necessary to go through set up again. However it will be necessary to reset the clock if 

required. 

Blank Screen 

First change batteries. If after changing batteries the screen stays blank the remote may 

need to be rebooted. Reset the remote by either putting the batteries in and out again or 

by pressing the recessed “RESET” button on the keypad with a pointed object like a pencil 

or paperclip. The remote will not lose its settings, but you will need to reset the clock. 

4