Airmaster Aero bounce 120 Assembly And Operating Manual - page 18
7
40
Slide one of the assembled FIBREGLASS RODS
halfway around the SAFETY NET hem -until
each end is just showing. Repeat the same
exercise with the second rod however in this
instance ensure that the end being pushed
through the hem is the opposite end of the
rod already pushed through on the other side
of the hem (ie if the metal connecter is at the
leading end of the first rod pushed through
then ensure that the leading end of the second
rod is the straight fibreglass end- this will
enable the two rods to be connected into a full
circle)
41
Have one person stand on two of the
unconnected rod ends then take the other
two ends and bend them forward toward the
centre of the net until they are at a matching
angle and are able to be connected.
42
To make the second connection and therefore
form a loop have one person stand on the join
made in the previous step and then push the
two remaining unconnected rods towards
the centre of the ring until they are in line
with each other and slide together. Slide the
net around the FIBREGLASS loop by a few
centimetres until the metal connectors are
hidden inside the hem.
43
Place the net with the FIBREGLASS Loop installed flat on top of the trampoline. Using a safety ladder,
securely positioned to the ground, lift the net up at the point of the relevant Net Pocket and clip
the FIBREGLASS Loop into one of the moulded groves located in the cap on one of the SAFETY NET
POLES. Repeat the same exercise until the NET is fully erected.
44