Airnet AIR-AP600GHP Quick installation manual - Configuration
PC
Configuration
3
Quick
Installation
Guide
9
www.netkrom.com
If you don’t use the uConfig Utility you need to establish Ethernet
connection between your PC and the AIRNET Indoor High Power Access
Point, by default the indoor AP has the IP address 192.168.168.1.
Therefore, your PC must be in the same network segment as the AIRNET
Indoor High Power Access Point is to get Ethernet connectivity. The
steps shown below are for Windows XP.
Step 1:
Go to Start button, then go to My Network Places and finally click on
Network Connections.
Right-Click over your network adapter and select Properties.
Step 2:
Select the Internet Protocol Option and then click in Properties.
Step 3:
Now configure the IP Address of your network adapter with an IP in
the same Network segment as your AIRNET Indoor High Power Access
Point is as it is shown in the picture, you don’t need to assign any
gateway address.
Press OK and then press the Close button.
300 Mbps
AIR-AP600GHP
High Capacity Wireless Networks