Airone RIGOLETTO 60 Instructions For Using Maintaining And Installing The Hood - page 2
INSTRUCTIONS FOR USING, MAINTAINING AND INSTALLING THE HOOD
ATTENTION: The hood must only be installed by a qualified technician.
The company accepts no liability if it is installed by an unauthorised person.
Please read these instructions carefully before beginning the installation. Conserve this handbook together with the hood
WARNINGS
Before cleaning or performing any periodic or urgent maintenance to the hood, ensure the power is turned off by removing the plug from
the socket and turning the main switch to 0 (off).
Do not connect the hood to any piping used for combustion appliances, such as burners, boilers or fireplaces.
Check that the main power supply corresponds to the voltage required by the hood, which is given on the silver label stuck inside the hood.
Ensure that the electric system is correctly earthed and that the earth discharge works correctly.
When cooking do not use any materials that could form high or unusual flames. Oil that has been used twice and fats are very dangerous
and could easily catch fire. Do not prepare flambè dishes under the hood. Respect local legislation and regulations issued by the relative
authorities regarding the exhaust air when the suction is operating.
Failure to respect and perform all the maintenance operations described in this handbook could cause a fire hazard.
INSTALLATION
The minimum safety distance between the bottom of the hood and the top of the cooking hob must be 65 cm., smaller distances must be
previously authorised by the manufacturer. (see installation drawings)
The hood can be used for both filtering and suction.
When the filtering function is operating, i.e. with air recycle, carbon filters must be used (refer to the paragraph on CARBON FILTERS).
When the suction function is operating, i.e. exhausting the filtered air on the outside, a suitable compensation system must be used ac-
cording to current standards in force. The diameter of the fume exhaust pipe must be the same or greater than the diameter of the hood
pipe union.
There must be sufficient ventilation in the room where the hood is installed, to allow the simultaneous use of other appliances that use gas
or other fuel.
ASSEMBLY INSTRUCTIONS
Attention: Before proceeding with the installation, make sure that the screws and the anchors already supplied, are suitable for
the type of wall the hood must be fixed to.
To assemble the hood use the accessories that are supplied and follow the instructions given in the enclosed handbook.
ELECTRIC WIRING
The electric wiring must be performed by a specialised electrician fully respecting current standards and legislation in force.
Check that the power supply corresponds to the voltage requested by the hood, which is given on the silver label stuck inside
the hood.
Connect the hood to the power supply using a bipolar switch with a minimum opening of 3 mm. The switch must be easy to reach when the
hood has been completely installed.
Ensure that the wiring system conforms to current standards and the earth discharge works efficiently.
Pay special attention to the hood power cable, ensure that it does not pass through any holes without a cable clamp.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified person in order to avoid a
hazard.
The manufacturer declines all responsibility if the current accident prevention standards in force are not respected, which are
needed for the wiring system to operate correctly