AirPac COOLIT 1000 Operation manual - page 16
16
CONTROL PANEL FUNCTIONS
Power on/off button
Press once to turn on and press again to turn off.
Mode Function button
Three function mode selection: cooling (top), dehumidifying
(middle) and fan (bottom). To operate the air conditioner, press
the function button and the cooling indicator light (top) will come
on. For dehumidifying only, press the function button once
again and the dehumidifying indicator light (middle) will come
on. For fan only, press the function button a third time and the
fan indicator light (bottom) will come on.
Louver button
The louvers direct the air distribution into the room. Press once
and the louvers will oscillate in a 70° arc, press once again to
stop the louvers from oscillating. You can keep the air
discharge in a particular direction by pressing the louver button
once the louvers are in the desired position.
Fan Speed Button
When the unit is operating in the cooling or fan mode function
this button is used to select the desired fan speed. Red
indicates high fan speed and green indicates low fan speed.
When the unit is operating in dehumidifying mode the fan only
runs on low speed.
COOLIT
1000
Control Panel.
17
CONTROL PANEL FUNCTIONS
Temperature & Timer Button
This button allows you to set the temperature and timer. To
operate the temperature function press the button once and the
temperature indicator light (bottom) will come on. The
temperature is adjusted up or down by pressing the arrow
buttons. The temperature range is from 60° to 90°. Press the
temperature & timer button once again and the timer indicator
light (top) will come on. Adjust the timer by using the arrow
buttons to select the number of hours the unit should run before
it turns off. This can be set to turn off at any time up to 12
hours.
Tank Full Indicator
If the condensate water tank is full or has not been correctly
seated then the indicator will flash and you will hear a beep.