Airrex HSC-18PLUS Operating Instructions And Parts Manual - Installation
Operating Instruction & Parts Manual
INSTALLATION
REMOTE CONTROL
Do not use the unit in explosive environments or in areas where flammable gas
leakage may occur.
Unlock the casters and push the unit to a flat, level surface and set the caster brakes to the locked position.
If the power cord or plug is damaged, repair should only be performed by qualified
electrical personnel.
Do not connect/disconnect the power cord or attempt to operate buttons with wet hands.
This could result in electrical shock.
Do not use the unit in a corrosive atmosphere.
Do not install the unit on uneven or sloping surface. The unit may roll or topple over
even if the casters are set to the locked position.
Do not use the unit in areas where it will be exposed to rain or water.
WARNINGS REGARDING PROPER LOCATION FOR INSTALLATION
MOVING THE UNIT
Check the prongs and surface of the power cord plug for dust/dirt. If dust and/or dirt are present, wipe off
with a clean, dry cloth.
Check the power cord, plug and prongs for damage or excess play.
If any damage or excess play is found, contact a qualified repair technician or a qualified electrician to perform
replacement or repair of the power cord, plug or prongs
PLUGGING IN THE UNIT
rev0
POWER
TIMER
UP/DOWN
Dry cell
COOL
FAN
■ Point remote control at machine receiver.
■ Remote control will not function where strong lights
such as 3 florescent, neon or strong sunlight interferes.
In this case use the remote control directly in front of
the receiver on the unit.
■ when the remote operates a “beep” sound
will confirm that the remote signal has been sent.
■ Remove batteries when you do not use the remote
control for long periods, as leakage can occur.
■ Ensure water and other liquids do not enter the remote control.
■ When using the remote control for the first time remove
the vinyl battery contact cover.
■ Open battery cover.
· Press ① part way in, in the direction shown by the arrow,
then pull the number ② part towards the direction shown by
the arrow.
■ Exchange Battery.
· Place as indicated +, -
■ Close cover
· push until cover “click”.
①
②
Vinyl