Åkerströms RX DIN USA Operating Manual - 8.2
Configuration of the receiver
12 (16)
Sesam 800 K3 RXDIN USA Manual
Document-ID: 946415-000
Version: A0
Author: SH
8.2
Advancedconfiguration
This configuration allows the user to determine which button activates a specific
relay.
1. Open the lid on the receiver, see basic configuration.
2. Press the Learn/Erase button until LED 7 is ON. The Learn Mode will be
active for 10 seconds.
a. Press the Learn/Erase button once in order to select relay one (the status
LED will flash once).
b. Press the Learn/Erase button twice in order to activate relay two (the
status LED will flash twice).
c. Press the Learn/Erase button three times in order to activate relay three
(the status LED will flash three times).
3. Press the button that shall be used for activating the selected relay in the
receiver. If the configuration is accepted by the receiver, LED 7 flashes 3
times.
4. Mount the lid on the receiver, see basic configuration.
8.3
Erasingalltransmittersinthereceiver
1. Open the lid on the receiver.
2. Press the Learn/Erase button until LED 7 is ON. The Learn Mode will be
active for 10 seconds.
3. Press the Learn/Erase button for 5 seconds (until LED 7 is OFF). All trans-
mitters are now erased from the receiver memory.
4. Mount the lid on the receiver.