Anhui Hualing HM-12 Operation Instruction Manual - page 6
4.4 FUNCTIONAL CHECK
To check the appliance works correctly proceed as follows;
Press the start button “turn over”and check that the screw feeder rotates anti-clockwise to the
outlet opening of the HM-12/HM-22/HM-22A;
By press the reverse button “on”check the grater roller changes direction and starts turning
clockwise;
Using the presser lever see if the appliance automatically stops.
5 USING THE APPLIANCE
5.1 CONTROLS
FIG 4-Controls
3
1-Start button “on”
2-Stop button “off”
3-Reverse button “turn over”
5.2 SETTING UP THE HM-12/HM-22/HM-22A FOR USE
N.B before using the appliance makes sure all the components that can be removed are secured in
position (see fig 6)
Mount the mincer outlet and block it into position using the handle located on the side of the
union;
Mount the screw feeder, blade and disk, and then screw on the lock nut.
5.3 FILLING THE MINCER(see fig5)
When using the mincer it is important that you stand in the correct position. Do not position yourself
so that any part of your body comes
In direct contact with the mincer when working. FIG 5-fitting the mincer
N.B The mincer must be filled when working. The procedure to follow is:
1. Place the food in the tray;
2. Start the mincer using the start button.
3. Raise the pestle;feed the meat into the
tube;Without forcing use the pestle to push
the meat into the opening.
4. If the meat suitably cut beforehand there should be no
problems with the screw feeder,however,if there are problems
tighten the lock nut until the meat is cut to desired size.
5. So both the disk and blade last longer and to maintain their sharpness in time:
- When all the meat has been minced turn off the appliance;
- Blade and disk must always be coupled.
6. Do not tighten the lock nut excessively;
1
2