Animo B100 User Manual - page 4
2015/04 Rev. 3.0
B100
8
GB
Please read this instructions carefully to ensure that the coffee maker is
operated properly and safely.
1. GENERAL DISCRIPTION
The Aromatic B100 is a semi-automatic coffee maker. Its sophisticated
construction, both of the housing and the water reservoir, makes this unit
particularly suitable for areas where hard water prevails. The Aromatic
B100 consists of the following standard components (see fig. 1):
A - housing
B - 2 glass coffee jugs with filling/ dispensing lid
C - 2 basket filters 90/250
D - measuring cup
E - ± 100 paper filters 90/250
2. TECHNICAL SPECIFICATION
Type
: B100
Hourly capacity (approx) : 20 litres
Buffer volume
: 3,6 litres
Minimum brewing volume : 1/2 jug
Power supply
: 1N~220-240V 50-60Cy
Power consumption
: 2275 W
Filter paper
: 90/250
Dimensions (see fig. 2)
Height : 510 mm
Width : 185 mm
Depth : 370 mm
3. OPERATION
Pour the water into the cold water reservoir (fig. 3A). The cold water flows
through the blender (fig. 3B) to the bottom of the water heater (fig. 3C),
pushing the hot water (fig. 3D) upwards. The hot water at 97°C pushed
up by the cold water can not go any higher than the blender (fig. 3E).
The hot water can only flow through the syphon (fig. 3G) to the spraying
plate (fig. 3F). Through this spraying plate the hot water is sprayed over
the coffee.
4. CONNECTING THE B100
Before connecting the appliance, make sure that the available local
voltage is the same as that shown on the type plate (fig. 4). The B100 is
supplied with a plug fitting a 230V wall socket with rim earthing. Before
connecting the appliance, first fill up the water heater with water (see 5.
PREPARATIONS BEFORE USE).
51
0
60
0
185
370
B100
fig. 2
A
B
C
E
G
F
D
fig. 3
B100
M A D E I N H O L L A N D
1N~220-240V 50-60Hz 2275W
10227 / 1R 02660
fig. 4.
B100
A
B
C
D
E
fig. 1