Animo WKT 5n HA User Manual - page 8
5. FIRsT TIME usE
The following procedure should be carried out to make a new appliance ready for use.
Model HA
1.
Fill the water boiler with water. Never fill up the water boiler higher than the ring indicating
“
MaX
”.
2.
Switch the water boiler on using the on/off switch (fig. 3D), the indicator lights (fig. 3A&B) will lit.
The water in the water heater will heat up. The green indicator light (fig. 3B) will light up the
water in the boiler has reached the correct temperature.
3.
Tap all of the first heated water out of the water boiler and discard it. Refill the water boiler with
fresh water. Fill up the water boiler with fresh water. After this, the appliance is ready for use.
Model VA
1.
Connect one side of the supported water supply hose between the swivel joint at
the backside of the machine (fig. 1-10) and the other side to a manually operated
water stop valve.
Be aware! Only cold water.
Open the water tap and check the connection for
leaks.
2.
Switch the water boiler on using the on/off switch (fig. 3D), the indicator lights
(fig. 3A&B) will lit for a while. The water heater will fill automatically. After this the water will
be heated up. During filling the yellow indicator light (fig. 3A). will lit. The green indicator light
(fig. 3B) will be on until the water has reached the required temperature.
3.
Tap all of the first heated water out of the water boiler and discard it. The water boiler will
automatically be refilled with fresh water.
2015/02 Rev. 1.0
M-LINE
17
GB