Anodyne Electronics Manufacturing SM40 Installation And Operation Manual - page 30
UT12-000 Universal Encoder/Decoder
SM40 Installation and Operation Manual
May 15, 2012 Rev: 5.00
Page 3-14
ENG-FORM: 806-0100.DOTX
CONFIDENTIAL AND PROPRIETARY TO ANODYNE ELECTRONICS MANUFACTURING CORP.
3.8 Configuration
Mode
3.8.1 Unit
Configuration
There are two methods of programming configurable information into the UT12. One is via serial load
using a PC and the UT12 serial load kit, the other is by pressing a special button sequence on the
UT12-000.
3.8.1.1
Serial Load Mode
To access the serial load mode, the UT12 must be connected to a PC running the serial load program
(AEM P/N FC48-000). For full details, see the Serial Load Manual.
If the UT12 is in the aircraft being serial loaded, ensure that the Control Head power is off. This is
because the Control Head and UT12 serial data lines are used both for communicating with each other
and with a PC for serial loading of data.
3.8.1.2 UT12
Mode
To access the configuration mode, the user must not be involved in any other operation.
can be
pressed to cancel any operations in progress. The
button is then pressed three times (this will
display the status screen on the control head), followed by the
button. At this point the display will
show
Config Esc=EXIT
. If the user wishes to abort the configuration option,
can be pressed to
cancel the operation, otherwise the
button can be used to scroll through the configuration screens.
The screens are:
Unit ID=UUUUU
Home Region = HH
Community Cd=CC (Community Code)
AFN Phone=PPPPP (Phone Code for AFN network)
LAM Phone=PPPPP (Phone Code for LAM network)
3.8.2 Configuration
Information
The following sequences and codes are programmable through the serial load program, or from the UT12
keypad using configuration mode.
Information
Tones
Details
Unit ID
UUUU
Home Region
HH
(LAM) 00-99.
–
Used in home region sequence 890HH
Community Code
CC
(LAM) 00-99.
–
Used in alarm call CC000 and CC400
AFN Phone Code
PPPPP
(AFN) 00000
–
99999. Used to call Phone Repeater.
LAM Phone Code
PPPPP
(LAM) 81091 or 81093. Used to call Phone Repeater.