Anova Perspective series Assembly Instructions Manual
!
anovafurnishings.com
888.535.5005 tel
TOOLS NEEDED:
•
5/32" Allen wrench
•
1/4" Allen wrench
•
3/16" Wire pull rod
•
5/16" Open-end or
box-end wrench
Assembly Instructions
Tandem Contour Benches
TAN3284P-4'
TAN3284T-4'
TAN3284FM-4'
TAN3284MR-4'
TAN3280FM-6'
TAN3280MR-6'
TAN3280P-6'
TAN3280T-6'
-
-
PERSPECTIVE
TOTEM
-
-
FRACTURED MOVEMENT
MOUNTAIN RANGE
&
&
&
&
BENCH COMPONENTS: Pattern may vary on the bench seat and backrest panels.
ASSEMBLY HARDWARE: All hardware is stainless steel.
(1) Bench Seat
ASSEMBLY:
Inspect the shipping container contents for damage and to determine that all components and hardware are present.
1.
2.
Lay all parts on a soft work surface or on the shipping packaging to prevent
damage to the finish.
3.
Locate one of the mounting flanges and one of LED light fixtures. Mount
the light fixture to the flange by inserting two 6-32 x 3/8" hex head bolts
through the mounting holes. Place two 6-32 x 5/16 Nylock nuts on the ends
of the screws and tighten them with the 5/16" open-end or box-end wrench.
Repeat this process to install the remaining LED light fixture to the other
flange.
NOTE: Before assembling the nuts to the bolts, it is recommended that a
light oil or petroleum jelly be applied to the screw threads.
(1) Left End
Casting
(1) Right End
Casting
(7) 1/4"-20 x 5/8"
Allen Head Screws
Perspective
Mountain Range
Totem
Fractured Movement
(2) Optional
Mounting Flanges
(1) Optional Back
Panel Wire Cover
(1) Optional Bench Seat
Aluminum Wire Cover
(2 or 3) Optional
LED Light Fixtures
(4) 6-32 x 3/8"
Hex Head Bolts
(4) 6-32 x 5/16"
Nylock Nuts
(8) 5/16"-18 x 1"
Allen Head Screws
(4) 5/16" Flat
Washers
Mounting Flange
LED Light
6-32 x 3/8"
Hex Head Bolt
6-32 x 5/16"
Nylock Nut
(1) Rear Backrest Panel
(1) Front Backrest Panel
(3) 1/4" Flat
Washers
CAUTION: Steps 3 – 10 are applicable for the assembly of optional 2-light and 3-light LED kits. For a 3-light LED
kit, include steps A – G on page 4.
NOTE: LED light kit components must be assembled and mounted to the bench before the panel assemblies.
1
This is a two-person assembly.
4' Benches will be available soon.
Additional Hardware Not
Included with Purchase
(2) Heat Shrink Crimp