Anprobe BT-120 User Manual - Battery Replacement

7

BATTERY REPLACEMENT

Power is supplied by 9V Alkaline Battery x1

The Identification Arrow LED on the receiver will not turn ON when 

replacement is needed. To replace the battery, remove the screw from the back 

of the meter and slide the battery door outward. Remove the battery from 

case bottom and replace it with a fresh 9V Alkaline battery.

MAINTENANCE AND REPAIR

If there appears to be a malfunction during the operation of the meter, the 

following steps should be performed in order to isolate the cause of the 

problem.

1. Check the battery. Replace the battery immediately when the receiver 

     LED doesn’t turn ON.

2. Review the operating instructions for possible mistakes in operating

     procedure.

Except for the replacement of the battery, repair of the meter should be 

performed only by a Factory Authorized Service Center or by other qualified 

instrument service personnel. The front panel and case can be cleaned with 

a mild solution of detergent and water. Apply sparingly with a soft cloth and 

allow to dry completely before using. Do not use aromatic hydrocarbons or 

chlorinated solvents for cleaning.