Anprobe BT-120 User Manual - Operation

4

OPERATION

Breaker and Fuse Identification

1. Plug the transmitter into an energized 120V wall outlet. Refer to Fig.1.

2. Make sure the red LED is ON to indicate that the outlet is energized.

3. Push the Power switch on the receiver to turn it ON. The receiver will beep

    and the Power LED will be lit.

4. At the breaker panel or fuse box, hold the receiver perpendicular to the 

breakers. Scan slowly all breakers once to calibrate the receiver.  

During this scan, the receiver may beep and flash at several breakers. This is a 

normal part of the identification process. Refer to Fig.2

5. Without touching the ON/OFF button,Start the scan another time to identify 

the right breaker or fuse. When the receiver beeps, the correct breaker has 

been identified.

6. Push and Hold the Power Switch for three (3) seconds to turn the receiver 

off. Beeping and flashing during the shutdown is normal.

7. Unplug the transmitter from the wall outlet.

 Ci

rcu

it T

rac

er

Tra

ns

mi

tte

r

Fig. 1

Fig. 2