Anritsu MG3700A MG3700A Product Introduction - page 7
Connection to LAN
MG3700A Vector Signal Generator
5
[Method 1: Direct connection] 4/4
3. Connection by Transfer&Setting of IQproducer
(The following describes the procedures in the state IQproducer that is the standard software of
MG3700A is installed.)
Open [IQproducer for MG3700A] from [Start] > [Programs] > [Anritsu Corporation].
Open [Transfer & Setting Panel] from [Transfer & Setting] of IQproducer.
When a [Connection to MG3700A]
window opens up automatically, enter
the IP address that was previously set
to MG3700A in the edit box and click
[Connect]. If you close the
[Connection to MG3700A] window by
mistake, you can reopen it by clicking
an icon
at the upper left of the
screen or [Connection] > [Connect]
on the menu bar.
A MG3700A icon is displayed on the
right side of a screen in completion
of the connection. Close the
[Connection to MG3700A] window
by clicking [Close] when the
connection is done properly.
Connection is completed.