Anser U2 User Manual - Repeat Print
S
S
E
E
C
C
U
U
R
R
I
I
T
T
Y
Y
S
S
E
E
T
T
U
U
P
P
20 |
PRINTING SETUP
Repeat Print
When enable this function, the printer will repeat print automatically as long
as you set the printer to corresponding parameters.
Press to set the parameters.
1. Press to select the STATUS ON/OFf.
2. Press to select the TRIGGER mode ON/OFf.
3. Press to select the INFINITE/FINITE PRINT
When the TRIGGER mode is ON and the OPTION is INTINITE, you need to
use photocell to get the trigger signal (External/Internal photocell).
1. Set the Printing DELAY
2. Set the Printing GAP (The distance between with two MSG’s beginning part)
3. Define the REPEAT times
When select the TRIGGER mode ON, there is no need of using
photocell you only need to set the corresponding Printing GAP to start the
repeat print (No times limitation)
Clean PrintHead
1. Press to setup.
When enable this function you are able to print black square for the
purpose of cleaning the PrintHead under dual channel mode.