Anser U2 User Manual - Notes And Warning
S
S
A
A
F
F
E
E
T
T
Y
Y
I
I
N
N
S
S
T
T
R
R
U
U
C
C
T
T
I
I
O
O
N
N
1 | SAFETY INSTRUCTION
Notes and Warning
NOTE: Important information that helps you make better use of U2.
WARNING: Indicating either potential damage to hardware or loss of data
and telling you how to avoid the problem.
S
S
A
A
F
F
E
E
T
T
Y
Y
I
I
N
N
S
S
T
T
R
R
U
U
C
C
T
T
I
I
O
O
N
N
S
S
Please retain this page nearby your printer for future reference.
Please follow the installation instructions for your safety.
Installation:
1.
Please note that once the PrintHead has been installed it is necessary to use
the guide bar to protect the PrintHead from damaged while printing. (Any
external damaged, included box collision without the guide bar will not be
covered by warranty)
2.
When you extract the ink cartridge from the holder, press it and take it out at
a 15 degree angle. Please note that any removal by excessive force will
damage the PrintHead.
3.
After the installation process is completed, please ensure ALL the screws are
tightened.
4.
The installation of a UPS is highly recommended because it helps to avoid the
damage that may be caused by power loss.
5.
It is highly recommended for users to correctly earth the printer. Furthermore,
it’s necessary to connect to a dedicate power socket.
6.
If the working environment is dusty, it is highly recommended clean the
nozzle regularly using a low level compressed air supply that is dry and clean.
Operation:
1.
The remote controller will turned off automatically after three minutes if it is
not being operated.
2.
Please keep the printing throw distance within 6mm to ensure the best
printing quality.
3.
When the lay-out appears to have ink excessive, please apply the wet wipe