Summary of FT-20
Page 1
1 ft-20 fire training fog machine user manual english © 2017 antari lighting and effects ltd..
Page 3: User Manual - English
3 user manual - english safety information please read the following safety information carefully before operating the machine. This information includes important safeguards about installation, usage, and maintenance. Pay attention to all warning labels and instructions in this manual and printed o...
Page 4
4 ․ before transporting the machine, make sure the fluid tank is completely drained. ․ fog fluid may present health risks if swallowed. Do not drink fog fluid. Store it securely. In case of eye contact or if fluid is swallowed, immediately look for medical advice. Unpacking and inspection immediatel...
Page 5
5 product overview ft-20s power base (optional) main power switch lock lever charger input output level adjustment knob wireless receiver socket wire remote socket xlr 3-pin dmx connector power input on / off switch control fog output nozzle dip switch.
Page 6
6 setting up step 1: place the machine on a flat surface and in a suitable large area with at least 50 cm open space around the machine. Step 2: fill the fluid tank with antari approved fluid. Step 3: charge the battery by plug the charger adaptor into a grounded electrical outlet. Yellow light on t...
Page 7
7 pull to release locking lever align and insert head unit to base step 5: to start making fog, locate the rotary knob on the back for output level adjustment, and press the button to start making fog, release to stop. Step 6: to turn off the machine, disconnect machine from battery base or power ba...
Page 8
8 operation control panel operation the machine can be operated with the on/off button and output level control knob located on the rear. When using on/off mode press and hold the button to make fog, release to stop. In continuous mode, press button once to make fog press again to stop. Dip switch 1...
Page 9
9 dmx operation making the dmx connection – connect machine to a dmx controller or to one of the machines in the dmx chain. The machine uses an 3-pin xlr connector for dmx connection, the connector is located on the rear of the machine. Address setup – use the dip switch located on the rear of the m...
Page 10
10 wtr-20 wireless operation (optional) wireless remote control system w-2 consists of a transmitter equipped with four buttons to activate, deactivate, increase and decrease fog output and an onboard receiver attached to the rear panel of ft-20 fog machine. W-2 wireless transmitter press [a] button...
Page 11
11 registering a transmitter transmitters can be paired or deleted from the receiver. Each receiver can pair up to 5 transmitters. Follow the steps below to pair or delete a transmitter from a receiver. To pair step 1: put dip switch 11 to on position step 1: led indicator will start blinking, press...
Page 12
12 service and maintenance ․ do not allow the machine to become contaminated. ․ remove dust from air vents with air compressor, vacuum or a soft brush. ․ only use a damp cloth to clean the casing. ․ before storing run distilled water through the system to help avoid condensing the pump or heater. ․ ...
Page 13
13 technical specifications voltage dc 12v (battery) ac 100-240v, 50 / 60hz (battery charger) heater 600w warm-up time 1 sec max. Operating time 11 min. At 100% output with battery fluid tank capacity 0.4 l fluid consumption 16 ml/min compatible fluid antari flm water-based fluid control option dmx ...
Page 16
16 c08ft0200