Antari FT-20 User Manual - page 11
11
Registering a transmitter
Transmitters can be paired or deleted from the receiver. Each receiver can pair up to 5
transmitters. Follow the steps below to pair or delete a transmitter from a receiver.
To Pair
Step 1: Put Dip switch 11 to ON position
Step 1: LED indicator will start blinking, press and hold [A] to pair
Step 2: Once pairing complete LED indicator will be constant on for 3 seconds
Step 3: Put Dip switch 11 back to OFF position to start operation.
To Delete
Step 1: Put Dip switch 10 to ON position
Step 2: LED indicator will start blinking, press and hold [A] to delete
Step 3: Delete process will take approximately 10 seconds
Step 2: Once deleting is completed LED indicator will be constant on for 3 seconds
Step 3: Put Dip switch 10 back to OFF position to start operation
Transmitter battery replacement
If the effective distance seems to decrease, it is possible the battery level is low and requires
replacement. In order to replace the battery, undo the three screws on the back of
transmitter to release the cover. Replace with same type and specification of battery which is
27A 12V
Fluid
Only use Antari FLM water-based liquid for the FT-20 Fire Training Fog
Machine. The machine is tested and calibrated with this liquid to get
the best output performance. Warranty will be void if any other type of
liquid is used, improper use of liquid may lead to machine failure and
malfunction.