Antari HZ-100 User Manual - page 4
•Operation
1.
Place the unit on a flat surface. Plug power cord into a grounded electrical outlet.
2.
Set the power switch to “ON” on the back of the machine. Make sure that the red
indicator light is on.
3.
Remove the black liquid tank cap, pour hazer liquid into the liquid tank about 1/2 full,
be careful not to exceed the maximum fluid level. DO NOT OVERFILL. Use only
dealer-recommended high-quality hazer liquid . Any other types of fluid may cause
health hazard and damage the unit. Use of any other liquid may void warranty.
4.
Connect the remote controller to the unit, press the red button ON/OFF to start up the
unit. (For further information on operating (including DMX) your Antari HZ-100,
300, and 400 Hazer, see the section titled, ”Remote Control Operation”).
5.
There’s an adjustable nozzle blade where you can adjust the angle of the haze output
by adjusting the thumb screws indicated below:
-
Antari HZ-100, HZ-300, and HZ-400
Haze machines produce safe, dry clean and
virtually invisible haze when used with HZL-1 Haze liquid with an extremely long hanging
time. For ideal results, haze when touch-up is needed.
•Caution
1. Always monitor and make sure that there is sufficient HZL liquid inside the tank during
operation.
2. Pour hazer liquid into the liquid tank about 1/2 full, be careful not to exceed the
maximum fluid level. DO NOT OVERFILL. The extra 1/2 tank space is reserved for
air-flow purpose. Overfilling will cause the unbalance in air pressure which will affect
the haze liquid to flow back to the compressor and may lead damage of the compressor
unit.
3. When the machine is operated for a longer period of time under open-air conditions,
falling dust/debris can enter the machine and may create residue inside the muffler of the
compressor. It will clog the filtration fibre on the muffler. Contact an authorized Antari
3