Anthem Integrated 2 Owner's Manual - page 4
Volume is adjusted through use of the Volume Control (C).
Turning this control clockwise increases the volume level
of both channels. Be sure the Volume Control (C) is
in the fully counter-clockwise position when turn-
ing the unit ON or returning to the OPERATE mode
after MUTING, to prevent damage to speakers,
amplifiers or the Integrated 2.
To record from a source, place the Tape/EPL-Source but-
ton (F) in the SOURCE position, select the source material
you wish to record via the Selector Switch (A), and com-
mence recording. To play back a tape recording, place the
Tape EPL/ Source button in the TAPE position.
Muting the Integrated 2 is achieved by placing the
Mute/Operate button (J) in the MUTE position (flashing
green LED); the output signal is then cut off. To resume
listening, place the button in the OPERATE position.
It is recommended that you shut OFF the main power via
the Power Switch (K) when not listening.
T R O U B L E S H O O T I N G
If at any time the Integrated 2 fails to work properly, consult
this checklist:
1. Check that the AC Detachable Power Cord is plugged into
the Integrated 2 Detachable Power Cord Socket (Q) and is
connected to a live source of AC power. For instance, if using
a power bar, check that the bar is turned on.
2. Ensure that all Input and Output connections are secu
a proper electrical contact.
3. DISCONNECT THE AC POWER CORD, wait 5 minutes
check that:
• A slo-blo fuse, with a rating of 4 Amp/250 V (2 Amp/2
for European and Asian versions), is installed in the fuse
er directly under the removable IEC power cord socket.
• The AC power fuse is intact and has not blown. If the
has blown, the thin metal conductor will have melted an
glass may appear “smoked”. If the fuse has blown, repl
with a fuse of the same rating (4 Amp/250V slo-blo for 1
120 volt countries and 2 Amp/250V slo-blo for 200 to 24
countries). (See Figure 5)
NOTE: Under no circumstances should you replace the
power fuse with one of a higher current rating! Doing so
cause further damage to the Integrated 2 and will also v
the warranty. In addition, your continued protection from
of fire or shock would be seriously compromised.
• Ensure the tubes are plugged firmly into their sockets
described in “INSERTION OF THE TUBES”.
5. Be sure the rest of the system is functioning properly
source unit, cables and connections, loudspeakers etc.)
6. With tubes, fuses, covers and power cords in place,
that the LED (H) is lighted (glowing light green). If all of t
above troubleshooting steps have been followed and th
is not lighted (remains dark green), contact your dealer
distributor for assistance.
R
P
F I G U R E 4
Fuse location in the Integrated 2 and removal.
WARNING-DISCONNECT THE AC
L
N
F I G U R E 3
Alignment of the AC power connector and detachable cord.
M
Q
O
Note: The fuse is not
accessible when the po
cord is plugged in.