Audient DLC ASP8024-DLC User Manual - Audio Routing

15

Audio routing

DLC has eight line inputs and outputs, labelled the

DLC VCA  Inputs/Outputs. These  are  accessible

on the rear of the console on DB25 connectors

(location depends on console configuration).

            METERS

Displays the level of the signal coming from the

source,  unless  the  DAW  Meters  switch  on  the

control surface is engaged.

            METERS POST VCA

Switches the meters between Pre and Post fader.

            SOURCE

The  audio  can  be  sourced  from  the  DLC   VCA

Inputs or the eight Sub Groups on the console. If

S GRP is selected, it breaks the signal to that Sub

Group, unless it is also selected as the destination

on that channel.

            DEST

The  eight  DLC  channels  can  be  assigned  to  the

DLC VCA Outputs or the Sub Groups. If S GRP is

engaged, it will replace all other channels routed

to the Sub Group, unless the Source button is also

set to S GRP.

             PAN

Pans the audio in the mix.

             MIX

Assign the output of the DLC channel to the Mix

Bus. You can therefore route the line level sources

directly to mix, effectively adding a further eight

channels to the console.

             SELECT

Selects the channel, for use with Unity and Auto

Safe Mode, as well as in the DAW Layer.

             CUT

Cuts  the  channel,  can  be  automated  in  the

Analogue Layer, and used in the DAW Layer.

             SOLO

Solos the channel in Analogue and DAW Layers.

This cannot be automated.

1

3

4

5

6

2

To insert the DLC channel

into a Sub Group and

automate it’s volume,

ensure that both the Source

and Destination buttons are

switched to S GRP.

7

8

9

1

2

3

4

5

6

7

8

9