Audient DLC ASP8024-DLC User Manual - Mac Installation
7
MAC Installation
SETTING MANUAL IP ADDRESSES
If you aren’t using DHCP to automatically set IP addresses,
you must set them manually on the DLC and Mac to ensure
the two devices are communicating correctly.
System Preferences > Network > Ethernet Tab > Configure
IPv4 Manually
Example:
Choose a unique IP address
by changing ‘X’ to a number
b e t we e n 1 - 2 5 4 , i n t h e
following IP address:
192 . 168 . 100 . X
This ‘X’ number must be
different on the DLC module
and the computer.
Set the Subnet Mask to
255 . 255 . 255 . 0
We recommend leaving
Router settings blank.
On the DLC Module, press
the Setup Button. The OLED
displays will show the first page
of the console setup.
Using the Page Keys underneath
the first encoder, page to the
right and ensure that Use DHCP
is set to
NO
in the next menu.
Setup Button
NETWORKING THEORY
On a network, devices must have a unique “address” to ensure they can communicate, this
is known as an IP address. You will need to decide whether your network will automatically
assign IP addresses to connected devices, or if you will manually assign them yourself.
If connecting DLC to your computer directly, you will most likely want to set the IP addresses
manually, however if connecting DLC to a larger network, typically the IP address will be
automatically assigned using “DHCP” (you will commonly have used this without realising
when connecting to things like WiFi networks).