Audio Authority 1352 User Manual - 5.0 Operating The Unit
7
5.0 OPERATING THE UNIT
Before installation, please make sure all devices you wish to connect
have been turned off.
• Connect a DVI HDCP compliant signal to the input connector using
premium quality cable.
• Connect two or four (depending on model) DVI HDCP compliant
devices to the Distribution Amplifi er’s outputs using premium
quality cable. *
• Plug the 9 VDC power adapter into the rear of the unit.
• Plug the Power Adapter into a working AC outlet.
• Power on all input and output devices.
• The DVI-HDCP input signal should now be available to all devices
connected to the device outputs.
* Note: An HDCP compliant monitor or other HDCP compliant device
must be connected to output number 1 for the other outputs of
the distribution amp to function properly. Once connected, this
output cannot be disconnected without adversely affecting the other
outputs. The reason for this requirement has to do with the copy
protection scheme used in HDCP devices and the DDC2 (Display Data
Channel) layer used to identify the characteristics of the connected
devices. Also, because of the DDC2 layer, the resolution capability
of the device on output number 1 is the defi ning factor for the
resolution of all other outputs. For this reason, if you intend to feed
monitors or projectors with the distribution amp outputs and the
resolution capability of the devices vary, make certain you connect
a device with resolution capability compatible with all monitors or
projectors to output number 1 of the distribution amp.