Audio Engineering Axium AX-400DA Instruction Manual - page 11
11
Typical System Configuration
–
Continued
FIG 1 depicts a typical configuration where the 400DA amplifier is providing audio into three of the possible
four listening zones.
Each zone consists of a room with a pair of speakers and a suitable controller.
Each zone may be listening to any of the connected sources: Satellite, DVD, Tuner, Internet Radio, Media
server, CD etc.
Controllers
Each zone has a specific control requirement.
Choose controllers that best suit the application.
• Zone 1 – The Gym: Keypad with IR receiver
• Zone 2 – The Study: Touch Panel Keypad
• Zone 3 – The Lounge: Tablet
The Axium Keypad’s may be plugged into any of the
four Controller ports.
Source control IR emitters are plugged into the IR
Ports. There are eight IR ports: IR1 – IR6, and SUM
IR1 – IR6.
IR1 – IR6 route source specific IR signals from
connected controllers, while SUM IR1 – IR6 output
the common IR or the sum of all received IR signals.
These Ports may be used for source equipment that
is common to all zones.
When controlling the 400DA using an iPad or other
Web tablet, the 400DA must be connected to a WIFI
enabled Ethernet router and the Web Tablet
browser must be directed to the 400DA’s IP
Address. The 400DA’s WEB application also provides
Source control functionality.
The 400DA can store and regenerate source
equipment IR commands.
The 400DA can be directed to output the IR
commands to a specific IR output port as required.
This advanced feature is programmed using the
Axium Keypad manager program (AKM)
Source Equipment
The 400DA amplifier has three stereo RCA audio
inputs for connecting to source equipment. These
input channels also feature Coax Digital inputs.
If a signal is present on the Digital input it takes
precedence over the Analog input.
There are three additional Coax Digital only input
channels.
A zone may select from any of the connected
sources. Someone in the Lounge may be listening to
the DVD, while another in the Study may be
listening to music from the media server.
All four zones may select the same source, in such
circumstances there is a possibility that all four
zones may be trying to control that source – not
always desirable – so a system should be well
planned and where appropriate additional source
equipment installed.
Speakers
Speakers in each zone are connected to the
amplifier by “Home Run” speaker cables.