Audio International AI-LCD68-01-xx Installation And Operation Manual - page 12
AI-LCD68-01-xx
Installation and Operation Manual
Document # 540260, Rev IR, 11/2004
Page 11 of 15
5.0
Troubleshooting Guide
5.1 Post-Installation
Test
5.1.1 Verify +28 VDC power has been connected to the unit.
5.1.2 Ensure that AI-LCD68-01-xx retains full range of motion (see
Section 6.0, Reference Drawings, for motion limits).
5.1.3 Ensure video can be seen on monitor.
5.2 Cleaning
Method
AI-LCD68-01-xx should be cleaned at least once every three (3) months
or when excessive dust or dirt becomes apparent.
Use a twin pack cleaning system that employs a wet pad pre-moistened
with an Isopropyl Alcohol based cleaner/anti-static solution and a lint-free
drying cloth. Audio International, Inc. recommends using “Kleen & Dry”
RR1205 manufactured by READ RIGHT, Nanuet, NY 10954.
Do not use benzene, ammonia, thinner, or any other volatile
substances to clean the monitor or screen. These chemicals may
damage the screen or internal circuitry.
Do not allow cleaner to puddle or pool around edges. Seepage
may damage internal circuitry.
Audio International’s recommended cleaning method follows:
A. Turn
off
monitor.
B.
Open pre-moistened pad and gently wipe evenly
across display glass. Do not allow solution to “pool”
or puddle around display edges.
C.
Immediately dry display using the absorbent, lint-free
cloth. Gently wipe display to a dry, clear finish.