Px-360 professional power amplifier professional stereo amplifier px-360 user’s manual.
2 2 power supply ensure that the insource voltage (ac outlet) matches the voltage rating of the product. Failure to do so could result in damage to the product and possibly the user. Unplug the product before electrical storms occur and when unused for long periods of time to reduce the risk of elec...
3 index 1. Introduction …………………………………………………………………….….. 3 2. Main features………………………………………………………………………. 3 3. Functions …………………………………………………….…………………….. 4 4. Applications ………………………………………………...……………….…….. 6 5. Technical specifications ……………………………...……………………...…… 8 6. Warranty ………………………………………………………………………....
4 1 introduction thanks for the acquisition of the px-360 audiopole. This professional power amplifier was developed for fixed installations requiring limited space in the bays. The px-360 has a high efficiency thanks to his class-d technology and can deliver 2 x 180 w rms on 4 ohms. It also works s...
5 3 functions front panel 1 – power power switch. 2 – volume volume control. 3 – power on power indicator. 4 – sig signal indicator. 5 – prot protection indicator. If the amplifier fails, the led lights up, the output being automatically muted. Check the cable connection between the amplifier and th...
6 3 functions rear panel 1 – mains and fuse main power supply socket. Make sure that the cable plug is correctly inserted in the socket. The compartment located below the socket contains the fuse. In the event of change, it is imperative to use a fuse with identical electrical characteristics under ...
7 4 applications two work modes can be selected: stereo or bridge mono. • stereo mode in stereo mode, channel 1 and 2 work separately using their own connectors and controls. Sélecteur en position stereo 6.
8 4 applications • bridge mode in bridge mono mode the power capacities of the two channels are cumulated to be used with one single load. The input signal must be connected to channel 1 of the amplifier. Channel 2 is not used and its volume control must be set to zero. Warning, the following connec...
9 6 technical specifications stereo power 2 Ω (eiaj) 2 x 400 w 4 Ω (rms) 2 x 180 w 8 Ω (rms) 2 x 100 w bridge mode power 8 Ω (rms) 360 w 4 Ω (eiaj) 800 w distortion (thd) frequency response 20 hz – 20 khz (+0/-1 db) damping factor, 1 khz > 180 @ 8 Ω s/n ratio, a weighted > 96 db gain (v) 28 ± 0,5 db...
7 warranty this device is warranted parts and labor against any manufacturing defects for a period of two years from the date of purchase by the first user. Conditions 1. The unit has been installed and implemented by observing the safety instructions in this operating manual. 2. The device was not ...
