Audio Resource Group ARG-TX90MST Manual

Summary of ARG-TX90MST

  • Page 1

    Dear arg customer, congratulations and thank you for purchasing arg’s 900mhz stationary transmitter. This device is easy to mount, convenient to operate with clear display and provides high-fidelity audio enjoyment. All of arg’s high quality products are designed to provide many years of reliable se...

  • Page 2

    This device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Fcc compliance statement...

  • Page 3

    900mhz stationary transmitter it allows the user to transmit the audio wirelessly in a certain range. Connect the audio source to the bal./unbal. Input on the back of the transmitter. Hook up the antenna to the front antenna jack or rear antenna jack and match the antenna selection switch. You can m...

  • Page 4

    Position. When there is digit “16” flash once on the display, it means that the device sampling rate is set at 16khz; when it is digit “8” flash once on the display, it means that it is set at 8khz. Input source xlr or 1/4” bal./unbal. Input rf output level set the rf output via rf power level switc...

  • Page 5

    Distorted audio a. Check to see if the source audio is distorted source. Correct or repair the audio source if necessary. B. Reset the audio select switch to match the source. C. Reset the hi-pass filter to adjust the frequency response. Reception troubles no reception a. Make sure the transmitter c...