B&B Electronics EIS-EXTEND-C Quick Start Manual - page 2
EIS-EXTEND-C-5009qsg
International Headquarters: 815-433-5100
www.bb-elec.com
European Headquarters: +353 91 792444
www.bb-europe.com
5
Ports
The Ethernet Extender has two ports, a RJ-45
10/100Base TX port and the Ethernet Extender port.
Existing coaxial cable can be used. If coaxial cable
requires termination, use BNC or F-connectors. F style
will require BNC to F-Type adaptor. When BNC extender
ports on the units are connected, Lnk LED should be lit.
BNC to F-Type Adaptor
Installing into Optional 9 inch Rack Chassis:
(model EIS-RACK-16)
The Ethernet Extender fits into any of the expansion
slots on a 19 inch rack chassis.
1. Install the Ethernet Extender onto a carrier
supplied with the chassis:
Unscrew the desired carrier from the rack chassis.
Fit the Ethernet Extender onto the carrier.
2. When the Ethernet Extender is completely
seated onto the carrier, insert the carrier on the
guide rails of the expansion slot.
3. Carefully slide the Ethernet Extender/carrier
assembly into the chassis until you have a firm fit.
4. With the carrier locking screw re-fasten the
carrier to the chassis.
Accessories
6