B&C Technologies EL-6 Computer Programming And Operating Instructions - Wash Program Creation
19
Programming
Wash Program Creation
When the machine is stopped, press the START
and RESET buttons together. The display is:
n?
Using the keypad, type 27 and press ENTER.
For two seconds, the display shows:
EDIT PROG. No.
At this prompt, type the program number you
wish to create or edit, followed by the ENTER
key. Again, two situations are possible:
>
The Program does not exist and must be
created.
>
The Program already exists and can be
viewed and modified.
Creating a new Wash Program
The display reads
NOT FOUND!
for two seconds, then:
C1>?
At this prompt, press ENTER. The display
changes to:
C1>PREWASH = ?
Using the INC or DEC key, you can select the
type of cycle to insert: Prewash, Wash, Spin,
Rinse, and Unroll. For example, if you wish to
insert a wash cycle you have named 3, press
INC until the display changes to:
C1>WASH = ?
Confirm the selection by pressing ENTER. The
display changes to:
C1>WASH = No.
Type 3 on the keypad, the press ENTER. Wash
3 is now stored as the first segment of the
program. The display will prompt you to enter
a second cycle:
C2>?
At this prompt, press ENTER. The choice of
cycle will be displayed as previously. Programs
can be compiled with up to 15 cycles chosen
from those in available in the cycles library (see
the EL6 Stock Programs Listing). The same
cycle can be used repeatedly in a wash
program. After you are through programming,
and have confirmed the last cycle, press STOP
to terminate programming. The display then
shows:
STORE?
Press ENTER to store the program. Press
RESET to cancel and return to the beginning If
while programming, you enter a wash cycle
that does not exist, the following message will
appear:.
NOT FOUND!
Since the wash cycle doesn’t exist, you will
have to create it before adding it to a wash
program.
Editing an Existing Program
In the event the wash program already exists,
the display will change to:
EXISTING!
for two seconds, followed by the display of the
program contents. For example:
C1>RINSE = 1
By using the INC or DEC keys, the various
cycles comprising the wash program can be
viewed. The program can be modified, and
cycles can be added or deleted.
Deleting a Cycle
Using the INC and DEC keys, find the cycle
you wish to delete. While the cycle is
displayed, press the delete key, then press the