B&C Technologies EL-6 Computer Programming And Operating Instructions - page 21

Programming

Wash Program Creation continued

20

STOP key when the display changes to:

STORE?

Confirm by pressing the ENTER key.  The cycle 

in question will be deleted, and the cycles 

following will be decremented by one.

Inserting a Cycle

To insert a cycle, use the INC and DEC keys to 

find the cycle that will follow the cycle you are 

about to insert.  The new cycle will be inserted 

just before the cycle displayed.  Now press the 

INS key, the request to enter a new cycle will be 

displayed:

C -> ?

Press ENTER to confirm that you wish to insert 

a new cycle:

Cn> PREWASH=?

Use the INC and DEC keys to go to the 

required cycle type and press ENTER to 

confirm.  You will then be asked to enter the 

cycle number:

Cn> PREWASH=N

After entering the cycle number and pressing 

the ENTER key, you can leave programming by 

pressing STOP.  The display changes to:

STORE?

Press the ENTER key to store the altered 

program.  All the following cycles will be 

incremented by one.  If you don’t want to 

change the program, press the RESET key 

rather than the ENTER key.  This will cancel all 

modifications made.

See the EL6 Stock Programs Listing, included 

with your machine, or available from our 

website (http://www.bandctech.com) for details 

of the cycles included with your machine from 

the factory.

Note:  The factory programs and cycles 

can be altered at will.  There is no way 

to restore the factory programming 

without manually inputting them, or via 

download with the EL6 Win 2 

programming software, also available for 

download on our website.

Note:  The factory programs and cycles 

can be altered at will.  There is no way 

to restore the factory programming 

without manually inputting them, or via 

download with the EL6 Win 2 

programming software, also available for 

download on our website.