B&D PanelPro SDO-4V1 Tri-Tran+ Owner's Manual - 8. Coding Transmitters
11
PanelPro
TM
SDO-4V1
Home Owner’s Manual
Diamond PD Power Drive : Instruction
Manual
© Copyright 2014 B&D Doors
8. Coding Transmitters
ELECTROCUTION! The button
cover is the only cover that should
be removed. All other covers must
remain in place.
Select one of the
four buttons you
wish to use to
control the door
Press DOOR
CODE button
four times then
press and hold
Select one of the
four buttons (not
programmed yet ) you
wish to use to control
the auxillary output
Fig. 8.2
8.4 Enabling AUX Output
a. Press the DOOR CODE button four (4) times - the
DOOR CODE LED will illuminate and the courtesy
light will flash quickly.
(Fig 8.2)
b. Press one of the four (4) buttons on the transmitter
for two (2) seconds, the DOOR CODE LED will
begin to flash, pause for two (2) seconds, then
press the same button again for two (2) seconds.
The DOOR CODE LED will illuminate for one
second then go out.
c. Press the transmitter button to test.
8.5 Setting PET (Pedestrian) Mode
The PET mode position is set during installation.
a. Press the DOOR CODE button five (5) times - the
DOOR CODE LED will illuminate and the courtesy
light will flash quicky (twice per second).
b. Press one of the four (4) buttons on the transmitter
for two (2) seconds, the DOOR CODE LED will
begin to flash, pause for two (2) seconds, then
press the same button again for two (2) seconds.
c. The DOOR CODE LED will illuminate for one
second and then go out, and the courtesy light
will also switch off. This indicates the code has
been stored.
d. Press the transmitter button to test.
8.6 Erasing Programmed Codes
If the DOOR CODE button is pressend and held for
six (6) seconds the DOOR CODE LED will blink rapidly
for one second to indicate that all programmed codes
have been erased.
d. Press and hold the transmitter button
for five (5) seconds to set Vacation
Mode. The DOOR CODE LED will stay
lit while Vacation Mode is active.
e. To reset Vacation Mode, press the same
button for two seconds, until the DOOR
CODE LED turns off.