B&D Roll-A-Door R1D Installation Instructions Manual - page 5
Revision 2 December 2013
OPENING REQUIREMENTS
The door is designed to be mounted behind the opening,
therefore you will need to measure and check:
OPENING WIDTH - As the door overlaps each side by
55mm or more, the door should be 110mm wider than the
opening. A wider door can be fitted as long as additional
sideroom and fixing is available. Refer drawing S01E to
S03E.
OPENING HEIGHT - The door will fit any opening height
up to the marked door size (the guides can be cut to suit).
After installation the walk-in clearance, under the door when
installed, will be reduced by approximately 80mm to allow
access to the handle.
LEVEL AND PLUMB - The door must be installed in an
absolutely level position, if opening is not level and square,
appearance and/or sideroom requirements will be affected.
Where jambs are out of plumb, extra sideroom or opening
modifications may be required to allow the door guides to
stand back from the opening edge. The floor should be level
or recessed across the opening to avoid gaps.
STRUCTURAL SUITABILITY - Ensure the structure
conforms to drawing S01E to S03E. If unsure, consult a
builder.
SIDEROOM - A minimum of 100mm (135mm desirable)
of sideroom is required behind the opening and should
extend above the head to allow for bracket fixing. Sideroom
on one side of minimum 140mm recommended, 190mm is
required if a B&D Controll-A-Door
®
garage door opener is to
be fitted now or in the future.
OBSTRUCTIONS - Ensure that the surface where the door
will be fitted is flush and smooth, and the area behind the
opening is free from any protrusions.
HEADROOM - See diagram below. If the door is installed
lower into the opening than shown, additional loss of walk-
in clearance will result. The fitting of a head infill panel
may also be necessary, in order to improve the external
appearance (See Alternative Fixings No. 2).
1.3 REQUIREMENTS BEFORE INSTALLATION
HEIG HT
W IDTH
S
ID
E
R
O
O
M
1
00
m
m
HEAD ROO M 350mm
460mm
430
230
350
80
230
85
80
395
315
120
80
370
250
450
80
85
335
250
415
35
35
460
460
460
460
120
HEIG HT
W IDTH
S
ID
E
R
O
O
M
1
00
m
m
HEAD ROO M 350mm
460mm
430
230
350
80
230
85
80
395
315
120
80
370
250
450
80
85
335
250
415
35
35
460
460
460
460
120
NORMAL HEADROOM
Up to 2200mm High
RESTRICTED HEADROOM
Up to 2200mm High
NORMAL HEADROOM
Over 2200mm High
RESTRICTED HEADROOM
Over 2200mm High
NOTE: Restricted headroom is NOT recomended for
windlocked or doors fitted with an opener
5
Series 1 Windrated Installation Instructions